Solution for the semi-trailer electrophoresis paint.
Product Introduction
HLS-5702LB/HLS-5780 Gray Cationic Epoxy Electrocoat for auto is the 7th generation electrophoretic coating researched and developed by HLS Paint (Shanghai) Co., Ltd. in cooperation with Germany HS International Chemical Industry Group. It represents modern technology of cathodic electrophoretic coating that is environment-friendly with high property and low cost. Such coating does not contain heavy metal like lead, tin, cadmium and mercury etc. It is a two-component, water-dispersed resin,meanwhile, it took in features of previous products, and can adapt galvanized steel sheet perfectly, almost can be applied to foundation coating of all metal, such as: cold and hot rolled steel sheet, galvanized steel sheet, aluminum products, zinc-aluminum alloy sheet and stainless steel sheet etc
This product features shown below:
| Good stability of bath can adaptable for a longer updating cycle. |
| The appearance of the coating is flat, delicate, smooth. |
| The bath has strong anti-shrinkage and anti-pollution ability. |
Main ingredients
1.Matrix resin: Acrylic modified epoxy resin
2.Solvent: alcohol ether
3.Pigment: carbon black, kaolin, antirust pigment
Product quality data
| Project |
Technical data |
Test standard |
| Resin (HLS-5702LB) |
Gray Paste(HLS-5780) |
| Appearance |
—— |
Milky white liquid |
Gray viscous liquid,no agglomeration |
Visual |
| pH |
25℃ |
6.0±1.0 |
—— |
GB/T 9724 |
| Conductivity |
25℃, μs/cm |
1100±400 |
—— |
HG/T 3334 |
| Storage stability |
No stratified state, and there were no obvious difference compared to before storage |
In 5-35 ℃ temperature 1 year |
Note: pH, conductivity measurement in the resin/pure water = 1:1 dilution
Storage, packaging and transportation
This product is a water-borne industrial coatings, non-hazardous, non-inflammable and explosive products; transportation to prevent direct sunlight, avoid freezing (>5℃ ); Packaging for 50/60/200L Plastic barrel; in the transport and storage of drums should be maintained clean, avoid charging the dirt brought in on drums during filling tank, again checked and confirmed that the quality of products, including paste resin, emulsions and additives should be indoor storage, good ventilation, dry, protect against freezing and overheating, the storage temperature should be controlled at 5～35℃, products from the date of production, over shelf, experimentation is required to determine whether can continue to use.
